Building Material Microscale Combustion Calorimeter BS EN 746-2 ASTM D7309

Building Material Microscale Combustion Calorimeter BS EN 746-2, ASTM D7309

Introduction:

It can determine the basic thermo-chemical data, such as Specific Heat Release rate, combustion calorific, Ignition Temperature, by testing very little specimen (1-10mg) in a few seconds, and predict the combustion retardant characteristics of the tested material.

Standards:

ASTM D7309-2007;

EMC 89/336/EEC;

LVD 72/23/EEC;

BS EN 60204-1, BS EN 746-2;

Features:

1. Anaerobic and aerobic pyrolysis;

2. Fast test speed, convenient for determine, it can finish the testing within several minutes;

3. High precise MFC(Mass Flow Controller) to control O2 and O2 flow: measurement range 20-200cm3/min;Response time less than 0.1S, accuracy: F.S±1%;

4. O2 sensor measurement range:0-100%, T90<6S, ±0.1%, accuracy: F.S±1%;

5. There is temperature sensor under the sample cup;

6. Automatically remove the sample cup into the combustion furnace;

7. Combustion furnace: Programmable control the heating temperature to specified temperature, swift of the temperature below 5K/h, with over-temperature protection function;

8. Temperature range: Room temperature-1000ºC; imported heating wire; high performance kanthal A-1 heating element;

9. With multiple cooling devices which is convenient for thermal dissipation;

10. LABVIEW software, PC and printer are optional, the software has following functions:

Display the running status of the equipment;

Calibrate the equipment and store calibration results;

Collect testing data;

Calculate heat release rate(W/g), combustion calorific(J/g), Ignition Temperature(°C);

Specifications:

Specimen size: 1-10mg, (typical specimen quality is 2-5mg), supply with precise balance with measurement range of 42g, 0.01mg.

Size: H:1570*W343*D663mm

Specimen heating speed: 0-2K/S

N2: 99.5% purity, pressure: 20 - 25 PSI

O2: 99.5% purity, pressure: 20 - 25 PSI